linksys wireless router dsl setup

I have AT & T DSL and am trying to configure a wireless router?

I used this particular router before but with another team in a facility high-speed cable. I am a little out of my reach with this, and am having extreme difficulities trying to get my router configured. In fact my router is a Linksys WRT54G and when I open the Linksys EasyLink Advisor to run the installation program still refuses to connect to my DSL router? Any suggestions at all would be a great help. Thank you. In a footnote added in this wireless router and the modem is connecting is the only that does not connect to Wireless Internet. If that makes any sense any one please help. Basically, the router does not detect wireless Internet signal from the modem.

Connect Modem [cable] for Wireless Router [] For PC. * = DO NOT REMOVE POWER TO RESET DEVICES RED * – Router OFF Set. – Modem Reset: With one clip, press the RESET button momentarily. – Wait 60 seconds. – Router POWER ON. – Reset router: With a clip, press the RESET button momentarily. – Wait 60 seconds. – PC Command Line: – Click Start] [- Click [Run ...] – type: cmd Click OK] [- At the prompt (c: \ .....>) type: ipconfig / release, press [ENTER] – At the prompt (c: \ …..>) type: ipconfig / renew, press [ENTER] – TEST: Open your Web browser: Connect to the Internet. – If success: Repeat steps after the PC command line in other equipment. – Failure to achieve: – At the prompt (c: \ …..>) type: ipconfig / all, press [ENTER] – Ensure DHCP enabled == YES – If the IP address 0.0.0.0 == O 169.254.0.0 to 169.254.255.255, connect modem [] cable to router [cable] for PC and perform all the steps again. –

router