Linksys WRT54G wireless router setup help!!!?
ok, so i set up the Linksys WRT54G wire to my Mac.
My Mac’s internet is from a cable hooking up to a cable box.
I put the Ethernet cable that came with the Linksys into one of the ports of the cable box.
and then unhooked th cable that provides internet to the computer from the cable box and hooked it into one of the 4 ports in the back of the wireless router.
I finally put in the IP address into the address bar and went through all the settings .
But then when i tried to continue to go onto other sites after the setup, the internet wasnt working.
Then i tried the internet on my PSP and it wasnt working either.
Whats the problem??
What am i doing wrong??
What do i need to do??
Your connection should be from the cable box the cat5 wire goes to the wan or internet port of the router.
The cable from the computer goes to one of the 4 ports on the back of the router.
Nothing will access the internet until you get this configured correctly.
You may have to go through the Linksys getting started section to actually connect to the internet.
Good luck
router
Comments on this entry are closed.