How do I set up my Netgear WGR614 router with Netzero DSL?
I have a Netgear WGR614 v6. I tried once already, My laptop connects to the router, but I can’t get on the Internet! I’m lost.
The wireless, internet, and LAN lights on the router are steady green, and the ethernet, DSL, and internet lights on my modem are steady green as well. I can access the internet by just plugging the ethernet cable straight from the modem to my laptop, but I want to go wireless.
I followed the directions on Netzero’s DSL support page, http://help.netzero.net/support/dsl/connect/set-wireless.html, and still no luck.
And now I can’t even access my router login page! I typed in http://192.168.1.1 and the page won’t load.
If you have the time and don’t mind a challenge I’d really appreciate the help!
P.S. If it makes any difference I bought the router online so it didn’t come with the resource CD.
Thanks!
Netzero says to disable DHCP on my router. Do I have to? If so, how?
Reset your router to DEFAULT.
=
Reset router: With a straightened paperclip, press RESET button 10-20secs.
=================
Connect (wired) Modem to Router (wireless) to PCs.
=
Set router POWER OFF.
-
Reset modem: With a straightened paperclip, press RESET button momentarily.
-
Wait 60 secs.
-
Set router POWER ON.
-
Reset router: With a straightened paperclip, press RESET button momentarily.
-
Wait 60 secs.
-
PC Command Line:
-
Click [Start] – Click [Run...] – enter: cmd, Click [OK]
-
At the prompt (c:\…..>) enter: ipconfig /release, press [ENTER]
-
At the prompt (c:\…..>) enter: ipconfig /renew, press [ENTER]
-
TEST: Connect to Internet.
-
If SUCCESS: Repeat Steps after PC Command Line on your other PCs.
-
If NO SUCCESS:
-
At the prompt (c:\…..>) enter: ipconfig /all, press [ENTER]
-
Ensure DHCP Enabled == YES
-
If IP Address == 0.0.0.0 OR 169.254.0.0 to 169.254.255.255, connect (wired) Modem to Router (wired) to PCs and perform ALL steps again.
-
router
Comments on this entry are closed.